Handles Easily.
Please follow the instructions below.

STANDARD TYPE
[for 1.0φ‾ 1.2 φ]
[for 1.5 φ‾ 2.5 φ]
The basic type with gripping mechanism. When fastened to the ceiling, the pin should point down. When suspended along the cable or fastened to the floor, the pin should point up.

1. Insert the cable all the way into the gripper from the pin side. The mechanism will grip the cable.

2. Press and hold the pin and pull out the cable.

IN-LINE FASTENING TYPE
[for 1.5 φ‾2.0 φ]

The Gripper can be attached and detached while the cable is fixed from the ceiling to the floor.

Loosen the cap 5 to 6 complete turns. Align the slots. To move up & down, loosen the cap slightly first, and follow the same procedure as the Standard Type. Tighten the cap when the position is determined. This will lock the Gripper in position.

"S" TYPE
[for 1.5φ‾2.5φ]
[3.0 φfor Stopper Cap Type]
The basic type with a double safety device. This type is used when additional safety to the standard type is required, or when you do not wish to move the grippers once they have been positioned.

1. Unscrew the cap

2. Insert the cable fully in the pin.

3. Screw the cap down tightly.

4. Loosen the cap when you want to move the Gripper

5. Press and hold the pin, and pull out the cable. To move the grippers up & down, unscrew the cap first, and adjust the position of the grippers. Make sure to tighten the cap when the adjustment is completed.

TS TYPE [for 3.0 φ]
- Grip + Fixing Screw
Fixing the cable by Gripper, then fix the cable with the fixing screw to add more safety.

1. Loosen the cap, and insert the cable fully into the pin.

2. Tighten the fixing screw after tightening the stopper cap.

SIDE EXIT HOLDER
[Described as "+T"]
Useful when you want leave cable uncut for greater adjustability.

Please note that it will be described with a "+T" when the side exit holder is mounted.

Follow the same procedure as the Standard type.